Volvo Trucks

I-Shift

Determine PTO / pump speed, calculate engine speed, hydraulic piston and gear pump specifications, pump part numbers, fitting dimensions, PTO part numbers and specifications, REPTO information, and more.

Volvo Trucks

Determine PTO output HP at required speed, PTO torque calculation, Engine Speed Requirements, Pump Bending Moment, and more.

Volvo offers excellent software tools to assist customers, service technicians and bodybuilders in performing their own diagnostic work on Volvo trucks and components.

Volvo Trucks

Volvo has and will develop unique solutions to meet customers’ needs, including adapting supplied frame drilling layouts to our hole-grid strategy. The existing solutions include, but are not limited to those in the attached PDF. For requests or quotations, Volvo dealers can call 800-832-5929 or e-mail gerald.saunders@volvo.com. For body builders or customers, please contact your local Volvo dealer to begin this process.

Volvo Trucks

Request Assistance

Request

Request Custom Drawing

To request a PDF drawing or CAD file, please contact your dealer.

Find a Dealer

News & Events

See all News & Events

3/2/2017

Volvo Body Builder Support to Attend CONEXPO

Please plan to visit us at Las Vegas Convention Center North Hall, booth #N10036.

Read more

2/27/2017

Volvo Introduces Auto Neutral for I-Shift

This new feature puts the new generation I-Shift in neutral when the parking brake is set.

Read more

1/27/2017

Custom Solutions

Volvo has and will develop unique solutions to meet customers’ needs.

Read more

Frequently Asked Questions

What is the minimum RPM I should operate my PTO, so that my vehicle will perform Regeneration during PTO mode?
Regeneration in PTO Mode - when a vehicle is being operated in PTO mode and a diesel particulate filter (DPF) regeneration is commanded, the engine must be run at a speed above the minimum speeds listed in the tables in Body Builder Manual, Section 9, Table of Contents / Regeneration in PTO Mode. The minimum speed setting can be affected by ambient temperature and/or altitude.
Can the I-Shift change gears while transmission mounted PTO is active?
When a I-Shift mounted PTO is engaged, it is only possible to move the truck in one gear (1st, 2nd, or 3rd) – the transmission will not shift gears when the PTO is active. The transmission will not disengage the PTO once it is turned on and recognized by the VECU or TECU via the factory-installed PTO switch.
On Volvo I-Shift, with PTO engaged while in neutral, and then selecting Drive the PTO stops turning. Why?
Remember that the I-Shift is an automated manual transmission with a clutch. With the PTO engaged while in neutral, when selecting Drive, the clutch is released, then the transmission shifts into gear. When the driver takes his foot off the brake pedal and presses the throttle pedal the clutch will reengage and the PTO will start to turn again. The transmission will not shift gears and driver is limited to about 6 MPH.
More